ASTM-D3233 2003
$40.63
D3233-93(2003) Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)
| Published By | Publication Date | Number of Pages |
| ASTM | 2003 | 10 |
1.1 These test methods cover two procedures for making a preliminary evaluation of the load-carrying properties of fluid lubricants by means of the Falex Pin and Vee Block Test Machine.
Note 1Additional information can be found in regarding coefficient of friction, load gage conversions, and load gage cablibration curve.
1.2 The values stated in SI units are to be regarded as standard. Because the equipment used in these test methods is available only in inch-pound units, the SI units are omitted when referring to the equipment and the test specimens.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Summary of Test Methods Significance and Use |
| 2 | Apparatus Reagents and Materials Preparation of Apparatus TABLE 1 |
| 3 | TABLE 2 FIG. 1 |
| 4 | Preparation of True Load Calibration Curve Calibration of Load Gage 4500 lbf (20 000 N) FIG. 2 FIG. 3 |
| 5 | Determination of Actual Gage Load for Run-In FIG. 4 FIG. 5 |
| 6 | Procedure Determination of Actual Gage Load for Run-In and 250-lbf (1112-N) True Load Increments TABLE 3 |
| 7 | Procedure Report Precision and Bias FIG. 6 |
| 8 | Keywords X1. COEFFICIENT OF FRICTION CALCULATION AND LOAD GAGE CONVERSIONS X1.1 FIG. X1.1 |
| 9 | FIG. X1.2 |
| 10 | FIG. X1.3 |
