Shopping Cart

No products in the cart.

ASTM-D3794 2018(Redline)

$39.00

D3794-18 Standard Guide for Testing Coil Coatings (Redline)

Published By Publication Date Number of Pages
ASTM 2018 12
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D3794-18

Redline Standard: Standard Guide for Testing Coil Coatings

ASTM D3794

Scope

1.1 This guide covers procedures for testing coil coatings. The test methods included are listed in Table 1. Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of test methods to be followed must be governed by the requirements in each individual case, together with agreement between the producer and user.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

absorbance; accelerated; acetic acid; adhesion; chip resistance; chromate; coil coatings; color; cone and plate; cyclic; density; dew cycle; film thickness; fame spread; fluorescent-UV condensation; Fresnel; glass transition; hardness; humidity; impact; irradiance; Kesternich; metamerism; methods; pH; phosphate; reflectance; salt spray; solar reflectance; solids; solvent resistance; standards; Taber; T bends; transmittance; viscosity; VOC; weathering; xenon; Zahn;

ICS Code

ICS Number Code 87.040 (Paints and varnishes)

DOI: 10.1520/D3794-18

ASTM-D3794 2018
$39.00