ASTM-D4617:2003 Edition

ASTM D4617

Scope

1.1 This classification system covers phenolic compounds suitable for compression, transfer, or injection molding, or a combination thereof.

1.2 This classification system is intended to be a means of calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection should be made by those having expertise in the plastics field after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the inherent properties of the material other than those covered by this classification system, and the economics.

1.3 The properties included in this classification system are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics important to specialized applications. These will be agreed upon between the user and the supplier, by using the suffixes specified in Section5.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 The following precautionary caveat pertains only to the test method portion, Section 13 of this classification system: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—ISO 800-1992(E) is similar but not equivalent to this classification system. Product classification and characterization are not the same.

Keywords

classification; description; PF; phenolic; plastics; properties

ICS Code

ICS Number Code 13.080.10 (Chemical characteristics of soil)

DOI: 10.1520/D4617-03