ASTM-F3042 2024

$34.13

F3042-13(2024) Standard Specification for Nonferrous Hex Socket, Slotted Headless, and Square Head Set Screws

Published By	Publication Date	Number of Pages
ASTM	2024	7

Guaranteed Safe Checkout

Categories: 21.060.10 - Bolts, screws, studs, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F3042-13-Reapproved2024

Active Standard: Standard Specification for Nonferrous Hex Socket, Slotted Headless, and Square Head Set Screws

ASTM F3042

Scope

1.1 This specification covers the requirements for nonferrous socket set screws sizes 0.125 (#5) through 2.000 in., square head set screws sizes 0.190 (#10) through 1.500 in., and slotted headless set screws 0.125 (#5) through 0.750 in. in diameter manufactured from a number of nonferrous alloys in use in the marine industry and the U.S. Navy subject to seawater wetting and salt atmosphere but that also may be used in other applications. It is recommended that copper-based alloys not be used in attempting to prevent mechanical components from rotating, such as locking shafts, because of the low hardness of the alloys. Some alloys or sizes or both of set screws may not be readily available. Manufacturers or suppliers should be contacted before design development or anticipated procurement.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: A complete metric companion to Specification F3042 will be developed—F3042M; therefore, no metric equivalents are shown in this specification.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

marine industry; nonferrous hex socket set screw; nonferrous slotted headless set screw; nonferrous square head set screw;

ICS Code

ICS Number Code 21.060.10 (Bolts, screws, studs)

DOI: 10.1520/F3042-13R24

Additional information

Standard Title	F3042-13(2024) Standard Specification for Nonferrous Hex Socket, Slotted Headless, and Square Head Set Screws
Published Code	ASTM
Publication Date	2024
Pages Count	7
ICS Codes	21.060.10 - Bolts, screws, studs