BS ISO 3468:2014
$102.76
Passenger cars. Windscreen defrosting and demisting systems. Test method
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
This International Standard specifies the test method for passenger car (ISO 3833:1977, 3.1.1) windscreen defrosting and demisting systems, when these are fitted.
This International Standard does not specify reference areas or levels of performance.
The test condition of −18 °C ± 3 °C specified for defrosting systems will meet the majority of cold climatic requirements.
The tests for demisting systems are conducted at a temperature of −3°C ± 1°C, since this is the practical minimum temperature at which mist, as defined in 3.7, can normally occur.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_3.3 Section sec_3.4 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | Section sec_3.5 Section sec_3.6 Section sec_3.7 Section sec_3.8 Section sec_3.9 Section sec_4 Section sec_4.1 Section sec_4.2 Section sec_4.2.1 Section sec_4.2.2 Section sec_4.3 Section sec_4.3.1 4 Test method for defrosting systems 4.1 Performance requirements 4.2 Test equipment 4.3 Test preparation |
| 11 | Section sec_4.3.2 Section sec_4.3.3 Section sec_4.3.4 Section sec_4.3.5 Section sec_4.3.6 Section sec_4.4 Section sec_4.4.1 Section sec_4.4.2 Section sec_4.5 Section sec_4.5.1 Section sec_4.5.2 Section sec_4.5.3 Section sec_4.5.4 Section sec_4.5.5 4.4 Test condition 4.5 Test procedure |
| 12 | Section sec_4.5.6 Section sec_4.5.6.1 Section sec_4.5.6.2 Section sec_4.5.6.3 Section sec_4.5.7 Section sec_4.5.8 Section sec_4.5.9 Section sec_4.5.10 Section sec_4.5.11 Section sec_4.5.12 Section sec_4.5.13 Section sec_5 Section sec_5.1 5 Test method for demisting systems 5.1 Performance requirements |
| 13 | Section sec_5.2 Section sec_5.2.1 Section sec_5.2.2 Section sec_5.3 Section sec_5.3.1 Section sec_5.3.2 Section sec_5.3.3 Table tab_1 5.2 Test equipment 5.3 Test preparation |
| 14 | Table tab_a Figure fig_1 |
| 15 | Section sec_5.3.4 Section sec_5.3.5 Section sec_5.3.6 Section sec_5.4 Section sec_5.4.1 Section sec_5.4.2 Section sec_5.4.3 Section sec_5.4.4 Section sec_5.4.5 Section sec_5.5 Section sec_5.5.1 Section sec_5.5.2 Section sec_5.5.3 5.4 Test conditions 5.5 Test procedure |
| 16 | Section sec_5.5.4 Section sec_5.5.5 Section sec_5.5.5.1 Section sec_5.5.5.2 Section sec_5.5.5.3 Section sec_5.5.6 Section sec_5.5.7 Section sec_5.5.8 Section sec_5.5.9 Section sec_5.5.10 Section sec_5.5.11 |
| 17 | Annex sec_A Annex sec_A.1 Annex sec_A.2 Annex A (informative) Recommended method of recording cleared area |
| 18 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Reference ref_6 Reference ref_7 Bibliography |
