IEEE 1349 2002
$65.54
IEEE Guide for Application of Electric Motors in Class I, Division 2 Hazardous (Classified) Locations
| Published By | Publication Date | Number of Pages |
| IEEE | 2002 | 78 |
New IEEE Standard – Inactive – Superseded. This guide was developed to assist individuals, organizations, and suppliers with the application of motors in Class I, Division 2 locations, where flammable gases and vapors may occasionally be present. Three-phase and single-phase ac synchronous and induction electric motors, fractional through very large sizes, are covered in this guide. Primary emphasis is on the use of general-purpose enclosures and precautions against excessive surface temperatures and sparking of rotor bars and enclosure joints. Results of motor surface temperature tests and calculations performed by Working Group Member companies are documented in the guide. Guidance is included for maintaining the life-cycle integrity of motors in Class I, Division 2 locations. Existing codes and standards contain cautionary notes for general-purpose motor applications in Class I, Division 2 areas. Industry experience and established practices are documented for the application of general-purpose motors in Class I, Division 2 locations and guidance is given for applying motors in these locations. This guide is not a specification and is not intended for use as a specification for purchasing motors installed in Division 2 locations.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Cover |
| 2 | IEEE Guide for the Application of Electric Motors in Class I, Division 2 Hazardous (Classified) Locations |
| 4 | Credits |
| 5 | Introduction Participants |
| 7 | Contents |
| 10 | IEEE Guide for the Application of Electric Motors in Class I, Division 2 Hazardous (Classified) Locations 1. Overview 1.1 Scope |
| 11 | 1.2 Purpose 1.3 Background |
| 12 | 1.4 Industry experience 2. References |
| 13 | 3. Definitions, abbreviations, and acronyms 3.1 Definitions |
| 15 | 3.2 Acronyms and abbreviations 4. Phenomenon of a motor as a possible ignition source |
| 16 | 4.1 Ignition overview 4.2 Ignition components |
| 17 | 4.3 Gas AIT and group designation 4.4 Gas ingress |
| 19 | 5. Common applications 5.1 Common application conditions |
| 20 | 5.2 Surface temperatures |
| 21 | 5.3 Sparking 5.4 General equipment considerations |
| 24 | 5.5 Application considerations for motors 1000V and below |
| 25 | 5.6 Application considerations for motors above 1000 V |
| 27 | 5.7 Application considerations for synchronous motors |
| 29 | 6. Uncommon application considerations |
| 30 | 6.1 High or low ambient temperature 6.3 Nonsinusoidal power or adjustable speed operations 6.2 High altitudes |
| 32 | 6.4 Duty cycle other than continuous 6.5 Excessive starts 6.6 High inertia load 6.7 NEMA Design C or D motors |
| 33 | 6.8 Voltage and frequency variation 6.9 Overload |
| 34 | 6.10 Atmospheres with an AIT at or less than those of Table 1 6.11 Motor exposed surface temperature above Table 1 values or above Class B rise |
| 35 | 6.12 Other considerations |
| 36 | 7. Operation and maintenance considerations 7.1 Commissioning considerations 7.2 Maintenance considerations for existing motors in Class I, Division 2 locations |
| 37 | 8. Motor surface temperature test methods |
| 39 | Annex AāBibliography |
| 42 | Annex BāRegulations and standards for motors used in areas where flammable gases or vapors may be present |
| 45 | Annex CāAIT and group designations for Class I materials |
| 50 | Annex DāMotor enclosures types |
| 53 | Annex EāMotor information tables |
| 56 | Annex FāMultisection motor inspection procedure |
| 57 | Annex GāMotor sparking considerations |
| 61 | Annex HāSurface temperature study results |
| 75 | Annex IāSurface temperature test methods |
| 78 | Annex JāEvent history |
Related products
-
IEEE 1800-2009
IEEE Standard for SystemVerilog–Unified Hardware Design, Specification, and Verification Language Published By Publication Date Numberā¦
-
IEEE 487 2007
IEEE Recommended Practice for the Protection of Wire-Line Communication Facilities Serving Electric Supply Locations Publishedā¦
-
IEEE 1329 2000
IEEE Standard Method for Measuring Transmission Performance of Handsfree Telephone Sets Published By Publication Dateā¦
-
IEEE 1349-2021/Cor 1-2022
IEEE Guide for the Application of Electric Machines in Zone 2 and Class I, Divisionā¦
-
IEEE P1635:2022 Edition
IEEE/ASHRAE Approved Draft Guide for the Ventilation and Thermal Management of Batteries for Stationary Applicationsā¦
-
IEEE 1532-2001
IEEE Standard for In-System Configuration of Programmable Devices Published By Publication Date Number of Pagesā¦
-
IEEE 1451.1 2000
IEEE Standard for a Smart Transducer Interface for Sensors and Actuators – Network Capable Applicationā¦
-
IEEE 1609.2-2022
IEEE Standard for Wireless Access in Vehicular Environments–Security Services for Application and Management Messages (Approvedā¦
-
IEEE 1379 2001
IEEE Recommended Practice for Data Communications Between Remote Terminal Units and Intelligent Electronic Devices inā¦
-
IEEE 1532 2001
IEEE Standard for In-System Configuration of Programmable Devices Published By Publication Date Number of Pagesā¦
-
IEEE ISO IEC C37.60 2012
High-voltage switchgear and controlgear – Part 111: Automatic circuit reclosers and fault interrupters for alternatingā¦
-
IEC 61883-8:2008
Consumer audio/video equipment – Digital interface – Part 8: Transmission of ITU-R BT.601 style digitalā¦
-
SMPTE ST 396:2003
SMPTE Standard – For Television ā Packet Format and Transmission Timing of DV-Based Data Streamsā¦
-
IEEE 802.16 2002
IEEE Standard for Local and Metropolitan Area Networks – Part 16: Air Interface for Fixedā¦
-
IEC 62286:2003
Service diagnostic interface for consumer electronics products and networks – Implementation for IEEE 1394 Publishedā¦
-
IEEE 1349-2021/Cor 1-2022
IEEE Guide for the Application of Electric Machines in Zone 2 and Class I, Divisionā¦
-
IEEE 1532 2003
IEEE Standard for In-System Configuration of Programmable Devices Published By Publication Date Number of Pagesā¦
-
BS EN 62286:2004
Service diagnostic interface for consumer electronics products and networks. Implementation for IEEE 1394 Published Byā¦
-
IEEE 1349-2021/Cor 1-2022
IEEE Guide for the Application of Electric Machines in Zone 2 and Class I, Divisionā¦
-
IEEE 1394-2008(Redline)
IEEE Standard for a High-Performance Serial Bus (Redline) Published By Publication Date Number of Pagesā¦
-
IEEE 1309 2005
IEEE Standard for Calibration of Electromagnetic Field Sensors and Probes, Excluding Antennas, from 9 kHzā¦
-
IEEE 269 2003
IEEE Standard Methods for Measuring Transmission Performance of Analog and Digital Telephone Sets, Handsets, andā¦
-
IEEE 1394-2008
IEEE Standard for a High-Performance Serial Bus Published By Publication Date Number of Pages IEEEā¦
-
IEEE 1394 2008
IEEE Standard for a High-Performance Serial Bus Published By Publication Date Number of Pages IEEEā¦
-
IEEE 1309-2005
IEEE Standard for Calibration of Electromagnetic Field Sensors and Probes, Excluding Antennas, from 9 kHzā¦
-
IEEE C37.60-2012
IEEE/IEC International Standard – High-voltage switchgear and controlgear – Part 111: Automatic circuit reclosers andā¦
-
UNE-EN 62286:2004
Service diagnostic interface for consumer electronics products and networks – Implementation for IEEE 1394 Publishedā¦
-
IEEE C62.82.2-2022(Redline)
IEEE Guide for the Application of Insulation Coordination (Redline) Published By Publication Date Number ofā¦
-
IEEE 11073-10429-2022
IEEE Standard for Health Informatics — Device Interoperability — Part 10429: Personal Health Device Communicationā¦
-
IEEE P1906.1.1:2020 Edition
IEEE Approved Draft Standard Data Model for Nanoscale Communication Systems Published By Publication Date Numberā¦
-
IEEE 1394-2008(Redline)
IEEE Standard for a High-Performance Serial Bus (Redline) Published By Publication Date Number of Pagesā¦
-
IEEE 1609.2-2022
IEEE Standard for Wireless Access in Vehicular Environments–Security Services for Application and Management Messages (Published)ā¦
-
IEEE C95.7-2022
IEEE Standard for Electromagnetic Energy Safety Programs, 0 Hz to 300 GHz (Approved Draft) Publishedā¦
-
IEEE C37.60-2012
IEEE/IEC International Standard – High-voltage switchgear and controlgear – Part 111: Automatic circuit reclosers andā¦
-
IEEE C37.60-2012
IEEE/IEC International Standard – High-voltage switchgear and controlgear – Part 111: Automatic circuit reclosers andā¦
-
IEEE 1149.6 2003
IEEE Standard for Boundary-Scan Testing of Advanced Digital Networks Published By Publication Date Number ofā¦
-
IEEE C95.7-2022(Redline)
IEEE Standard for Electromagnetic Energy Safety Programs, 0 Hz to 300 GHz (Redline) Published Byā¦
-
IEEE 524 2004
IEEE Guide to the Installation of Overhead Transmission Line Conductors Published By Publication Date Numberā¦
-
IEEE STD 1349 2001:2002 Edition
IEEE Guide for the Application of Electric Motors in Class I, Division 2 Hazardous (Classified)ā¦
-
IEEE 1363.2 2009
IEEE Standard Specification for Password-Based Public-Key Cryptographic Techniques Published By Publication Date Number of Pagesā¦
