IEEE 1613 2009
$46.04
IEEE Standard Environmental and Testing Requirements for Communications Networking Devices Installed in Electric Power Substations
Published By | Publication Date | Number of Pages |
IEEE | 2009 | 56 |
Revision Standard – Active. Service conditions, electrical ratings, thermal ratings, and environmental testing requirements are defined for communications networking devices to be installed in electric power substations. This standard establishes a common reproducible basis for designing and evaluating communications networking devices and the communications ports of protective relays for use in this harsh environment.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Stds 1613-2009 Front Cover |
2 | Title Page |
3 | Abstract/Keywords |
5 | Introduction |
6 | Notice to users Laws and regulations Copyrights Updating of IEEE documents Errata Interpretations Patents Participants |
9 | Contents |
11 | Important Notice 1. Overview 1.1 Scope 1.2 Purpose |
12 | 2. Definitions and word usage 2.1 Definitions 2.2 Word usage |
13 | 3. Service conditions (adapted from IEEE Std C37.90-2007 [B8]) 3.1 Usual service conditions |
14 | 3.2 Other conditions 3.3 Altitude |
15 | 4. Electrical ratings of control power inputs—adapted from IEEE Std C37.90-2007 [B8] |
16 | 4.1 DC rated control power inputs 4.2 Allowable ac component in dc control voltage supply 4.3 AC rated control power inputs 5. Insulation tests 5.1 General requirements |
17 | 5.2 Dielectric power frequency test |
18 | 5.3 Impulse voltage test |
20 | 6. Surge withstand capability (SWC) tests 6.1 Scope 6.2 Purpose 6.3 Test waveforms |
22 | 6.4 Test generator characteristics |
23 | 6.5 Verification of test generator characteristics |
24 | 6.6 Equipment to be tested 6.7 Test points 6.8 Application of test wave 6.9 Conditions of tests |
25 | 6.10 Coupling to test generator |
29 | 6.11 Test procedures |
31 | 6.12 Device performance classes 6.13 Conditions to be met (acceptance criteria) |
32 | 6.14 Test records |
33 | 7. RF susceptibility tests 7.1 Scope 7.2 Purpose 7.3 Test severity level |
34 | 7.4 Test equipment 7.5 Test setup |
35 | 7.6 Test procedure |
36 | 7.7 Device performance classes 7.8 Conditions to be met (acceptance criteria) |
37 | 7.9 Test records |
38 | 8. Electrostatic discharge tests |
39 | 8.1 Electrostatic discharge disturbance tests 8.2 Test procedure |
44 | 8.3 Device performance classes 8.4 Conditions to be met (acceptance criteria) |
45 | 8.5 Test data records 9. Vibration and shock |
46 | 10. Device cooling |
47 | Annex A (normative) Verification of test generator characteristics |
51 | Annex B (informative) Transceiver field strength |
53 | Annex C (informative) Test waveform specification |
54 | Annex D (informative) Field strength calibration, IEC 61000-4-3, 2002 [B5] |
56 | Annex E (informative) Bibliography |