Shopping Cart

No products in the cart.

IEEE C63.5 2004

$44.96

American National Standard for Electromagnetic CompatibilityRadiated Emission Measurements in Electromagnetic Interference (EMI) ControlCalibration of Antennas (9 kHz to 40 GHz)

Published By Publication Date Number of Pages
IEEE 2004 73
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Revision Standard – Active. Superseded by ANSI C63.6-2006 Methods for determining antenna factors of antennas used for radiated emission measurements of electromagnetic interference (EMI) from 9 kHz to 40 GHz are provided. Antennas included are linearly polarized antennas such as loops, rods (monopoles), tuned dipoles, biconical dipoles, log-periodic dipole arrays, hybrid linearly polarized arrays, broadband horns, etc., which are used in measurements governed by ANSI C63.4-2001. The methods include standard site (i.e. 3-antenna), reference antenna, equivalent capacitance substitution, standard transmitting loop, standard antenna, and standard field methods.

PDF Catalog

PDF Pages PDF Title
1 Cover
2 Title Page
3 Abstract/Keywords
5 Introduction
Participants
8 CONTENTS
11 1. Scope
2. References
12 3. Definitions
13 4. General test conditions
4.1 Introduction
14 4.2 Calibration measurement geometry
4.3 Test site and instrumentation
15 4.4 Antenna factors
16 4.5 Methods of antenna factor determination
5. Standard site method (30 MHz to 40 GHz)
5.1 General
19 5.2 Description of method
21 5.3 Measurement procedures
24 6. Reference antenna method (30 MHz to 1 GHz)
6.1 Calibration of other antennas using the reference dipole ant
25 6.2 Description of the reference antenna
26 7. Equivalent capacitance substitution method
27 7.1 Radio-noise meter and signal generator procedure
7.2 Network analyzer procedure
29 Annex A (informative) Determination of the maximum received field (Tables 2 and 3)
32 Annex B (informative) The discrete frequency calibration method
38 Annex C (informative) The reference antenna
40 Annex D (informative) Monopole performance equations
42 Annex E (informative) Example drawings of reference antenna [B5]
48 Annex F (informative) Rationale for geometry specific correction factors for biconical dipoles used in the normalized site attenuation test
50 Annex G (normative) Biconical dipole antenna correction factors (30-200 MHz) for calibration and normalized site attenuation
57 Annex H (normative) Procedure for measuring geometry specific correction factors for broadband antennas and reference-site requirements
64 Annex I (informative) Guideline for computing estimated measurement uncertainties in SSM antenna calibrations
72 Annex J (informative) Bibliography
IEEE C63.5 2004
$44.96